LaserPower Version I The photoelements react to direct irradiation of more than approx. 7000 - 10,000 LUX. The maximum solar radiation in July in clear air is approx. 140,000 lux. This statement applies to LaserPower rifles of version I. LaserPower II and higher versions This does not apply to LaserPower II, III and IV, [...]
Information on the scope of deliverey the individual models can be found in our catalogs, data sheets and/or on the product page of the respective model.
What is the scope of deliverey for the LaserPower? Read more "
Please only use original ANSCHÜTZ power supply units that are specially adjusted and configured for our laser targets. The positive pole is inside, the negative pole is outside. The power supply units have an output voltage of 6.0 V. The targets are equipped with reverse polarity protection, i.e. the battery circuit is switched off when the power supply unit is plugged in. This means that the batteries do not have to be
The diameter depends on the distance. At 10 m, the laser beam has a diameter of approx. 4.5 mm.
The hits are only displayed if the laser beam hits the target with approx. 3/4 of its diameter.
Is a hit indicated up to min. 1/2 bullet diameter as with the bullet? Read more "
Never close the bolt when the safety flag is inserted, otherwise the loading mechanism will be bent and the required action pressure can no longer be applied to the barrel. Malfunction.
Important information on handling the safety flag. Read more "
The compressed air cylinders may be filled with a maximum filling pressure of 200 bar at room temperature. This maximum permissible filling quantity must not be exceeded under any circumstances. Use only oil- and water-free compressed air (DIN EN 12021 - breathing air)! Due to legal and safety regulations, we deliver the compressed air cylinders unfilled.
What filling pressure is permitted for ANSCHÜTZ compressed air cylinders ? Read more "
Information on this can be found in these assembly instructions.
What must be observed when attaching an ALU stock to an ANSCHÜTZ 2002 air rifle? Read more "
Filled compressed air cylinders must not be exposed to temperatures below -20° C and above +70°C. Therefore, ensure appropriate insulation during transportation or storage, e.g. by storing them in polystyrene packaging or in a rifle case. Only unfilled compressed air cylinders may be transported on airplanes, by post, etc. Please follow the instructions
What is the maximum ambient temperature allowed for compressed air cylinders ? Read more "
Directly to the product website:
© J.G. Anschütz GmbH & Co. KG
